IRF链路聚合（链路聚合bfd）

IRF链路聚合（链路聚合bfd）

SW1配置

[IRF]int range ten1/0/49 ten1/0/50[IRF-if-range]shutdown[IRF]irf member 1 priority 5[IRF]irf-port 1/1[IRF-irf-port1/1]port group interface Ten-GigabitEthernet 1/0/49[IRF]irf-port 1/2[IRF-irf-port1/2]port group interface Ten-GigabitEthernet 1/0/50[IRF]int range ten1/0/49 ten1/0/50[IRF-if-range]undo shutdown[IRF]irf-port-configuration active

SW2配置

[SW2]int range ten1/0/49 ten1/0/50[SW2-if-range]shutdown[SW2]irf member 1 renumber 2保存并重启生效[SW2]irf-port 2/2[SW2-irf-port2/2]port group interface Ten-GigabitEthernet 2/0/49[SW2]irf-port 2/1[SW2-irf-port2/1]port group interface Ten-GigabitEthernet 2/0/50[SW2]int range ten2/0/49 ten2/0/50[SW2-if-range]undo shutdown[SW2]irf-port-configuration active

验证SW1和SW2是冗余

链路捆绑配置

IRF交换机聚合配置

#创建聚合接口1[IRF]int Bridge-Aggregation 1#批量进入端口[IRF]int range GigabitEthernet 1/0/1 GigabitEthernet 2/0/2#将端口加入聚合组1[IRF-if-range]port link-aggregation group 1

调试命令

#查看明细[IRF]display link-aggregation verbose

[IRF]dis int brief

版权声明：本文内容由网络用户投稿，版权归原作者所有，本站不拥有其著作权，亦不承担相应法律责任。如果您发现本站中有涉嫌抄袭或描述失实的内容，请联系我们jiasou666@gmail.com 处理，核实后本网站将在24小时内删除侵权内容。