CCNP(BSCI)实验：配置ISIS ipv6实验

CCNP(BSCI)实验：配置ISIS ipv6实验

R2(config)#ipv unR2(config)#int lo0 R2(config-if)#ipv add 3000:1::1/96R2(config-if)#int s2/1R2(config-if)#ipv add 1000::2/64R2(config-if)#no sh

实验过程：第一步：在R1、R2上配置ipv6 isisR1(config)#int lo0R1(config-if)#ipv router isis liboR1(config-if)#int s2/1R1(config-if)#ipv router isis liboR1(config-if)#router isis liboR1(config-router)#net 49.1111.1111.1111.1111.00

R2(config)#int lo0R2(config-if)#ipv router isis liboR2(config-if)#int s2/1R2(config-if)#ipv router isis liboR2(config-if)#exiR2(config)#router isis liboR2(config-router)#net 49.1111.2222.2222.2222.00

第二步：调试R1#sh clns nei

System Id Interface SNPA State Holdtime Type ProtocolR2 Se2/1 HDLC Up 24 L1L2 IS-IS

R1#sh ipv6 routeIPv6 Routing Table - 7 entriesCodes: C - Connected, L - Local, S - Static, R - RIP, B - BGPU - Per-user Static routeI1 - ISIS L1, I2 - ISIS L2, IA - ISIS interarea, IS - ISIS summaryO - OSPF intra, OI - OSPF inter, OE1 - OSPF ext 1, OE2 - OSPF ext 2ON1 - OSPF NSSA ext 1, ON2 - OSPF NSSA ext 2C 1000::/64 [0/0]via ::, Serial2/1L 1000::1/128 [0/0]via ::, Serial2/1C 2000:1::/96 [0/0]via ::, Loopback0L 2000:1::1/128 [0/0]via ::, Loopback0I1 3000:1::/96 [115/20]via FE80::C892:4FF:FE0C:0, Serial2/1L FE80::/10 [0/0]via ::, Null0L FF00::/8 [0/0]via ::, Null0

第三步:测试R1#ping 3000:1::1 so lo0

Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 3000:1::1, timeout is 2 seconds:!!!!!Success rate is 100 percent (5/5), round-trip min/avg/max = 4/12/24 ms

版权声明：本文内容由网络用户投稿，版权归原作者所有，本站不拥有其著作权，亦不承担相应法律责任。如果您发现本站中有涉嫌抄袭或描述失实的内容，请联系我们jiasou666@gmail.com 处理，核实后本网站将在24小时内删除侵权内容。