CCNA实验：配置帧中继Hub and spoke 多点子接口（思科帧中继实验配置）

CCNA实验：配置帧中继Hub and spoke 多点子接口（思科帧中继实验配置）

R1(config)#int s3/0.1R1(config-subif)#fr map ip 172.16.0.2 102 bR1(config-subif)#fr map ip 172.16.0.3 103 b（在多点子接口下添加手动dlci与ip地址的映射）R1(config-subif)#exitR1(config)#exitR1#

R1#sh fr map Serial3/0.1 (up): ip 172.16.0.2 dlci 102(0x66,0x1860), static,broadcast,CISCO, status defined, activeSerial3/0.1 (up): ip 172.16.0.3 dlci 103(0x67,0x1870), static,broadcast,CISCO, status defined, active（现在查看已经加入成功了）第六步：在R1上测试pingR1#ping 172.16.0.2

Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 172.16.0.2, timeout is 2 seconds:!!!!!Success rate is 100 percent (5/5), round-trip min/avg/max = 8/21/36 msR1#ping 172.16.0.3

Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 172.16.0.3, timeout is 2 seconds:!!!!!Success rate is 100 percent (5/5), round-trip min/avg/max = 8/20/44 msR1#

版权声明：本文内容由网络用户投稿，版权归原作者所有，本站不拥有其著作权，亦不承担相应法律责任。如果您发现本站中有涉嫌抄袭或描述失实的内容，请联系我们jiasou666@gmail.com 处理，核实后本网站将在24小时内删除侵权内容。