链路聚合LACP模式配置（lacp链路聚合作用）

链路聚合LACP模式配置（lacp链路聚合作用）

链路聚合LACP模式配置

[SW1]int g0/0/4

[SW1-GigabitEthernet0/0/4]port link-type acces[SW1]vlan batch 10 20Info: This operation may take a few seconds. Please wait for a moment...done.[SW1]int g0/0/4[SW1-GigabitEthernet0/0/4]port default vlan 10[SW1]int g0/0/5 [SW1-GigabitEthernet0/0/5]port link-type acces[SW1-GigabitEthernet0/0/5]port default vlan 20[SW1-GigabitEthernet0/0/5]q [SW1]int Eth-Trunk 1 [SW1-Eth-Trunk1]mode lacp-static [SW1-Eth-Trunk1]trunkport g0/0/1Info: This operation may take a few seconds. Please wait for a moment...done.[SW1-Eth-Trunk1]trunkport g0/0/2Info: This operation may take a few seconds. Please wait for a moment...done.[SW1-Eth-Trunk1]trunkport g0/0/3Info: This operation may take a few seconds. Please wait for a moment...done. [SW1-Eth-Trunk1]lacp preempt enable [SW1]dis eth-trunk 1 [SW1]int Eth-Trunk 1[SW1-Eth-Trunk1]port link-type trunk [SW1-Eth-Trunk1]port trunk allow-pas vlan all[SW1-Eth-Trunk1]q[SW1]int g0/0/1 [SW1-GigabitEthernet0/0/1]shutdown [SW1-GigabitEthernet0/0/1]q [SW1]dis eth-trunk 1[SW1]int g0/0/1[SW1-GigabitEthernet0/0/1]undo shutdown

[SW2]lacp priority 100 /设置优先级100[SW2]int Eth-Trunk 2 [SW2-Eth-Trunk2]max active-linknumber 2 /设置链路最大连接数[SW2-Eth-Trunk2]q [SW2]dis eth-trunk 2[SW2-Eth-Trunk2]lacp preempt enable /设置抢占功能

版权声明：本文内容由网络用户投稿，版权归原作者所有，本站不拥有其著作权，亦不承担相应法律责任。如果您发现本站中有涉嫌抄袭或描述失实的内容，请联系我们jiasou666@gmail.com 处理，核实后本网站将在24小时内删除侵权内容。