如何重置3850交换机密码（cisco3650交换机 重置密码）

如何重置3850交换机密码（cisco3650交换机 重置密码）

SUMMARY STEPS：

Connect a terminal or PC to the switch. Set the line speed on the emulation software to 9600 baud. Power off the standalone switch or the entire switch stack. Reconnect the power cord to the or the active switch. Within 15 seconds, press the Mode button whilethe System LED is still flashing green. Continue pressing the Mode button until all the system LEDs turnon and remain solid; then release the Mode button. After recovering the password, reload the switch or the active switch . Power on the remaining switches in the stack.

DETAILED STEPS：Step 1 ：Connect a terminal or PC to the switch.• Connect a terminal or a PC with terminal-emulation software to the switch console port. If you are recovering thepassword for a switch stack, connect to the console port of the active switch or• Connect a PC to the Ethernet management port. If you are recovering the password for a switch stack, connect tothe Ethernet management port of a stack member .Step 2 ：Set the line speed on the emulation software to 9600 baud.Step 3 ：Power off the standalone switch or the entire switch stack.Step 4 ：Reconnect the power cord to the or the active switch. Within 15 seconds, press the Mode button while the System LEDis still flashing green. Continue pressing the Mode button until all the system LEDs turn on and remain solid; then releasethe Mode button.•Switch:Xmodem file system is available.Base ethernet MAC Address: 20:37:06:4d:e9:80Verifying bootloader digital signature.The system has been interrupted prior to loading the operatingsystem software, console will be reset to 9600 baud rate.

proceed to the Procedure with Password Recovery Enabled section, and follow the steps：

Step 1 Initialize the flash file system.Switch: flash_initStep 2 Ignore the startup configuration with the following command:Switch: SWITCH_IGNORE_STARTUP_CFG=1Step 3 Boot the switch with the packages.conf file from flash.Switch: boot flash:packages.confStep 4 Terminate the initial configuration dialog by answering No.Would you like to enter the initial configuration dialog? [yes/no]: NoStep 5 At the switch prompt, enter privileged EXEC mode.Switch> enableSwitch#Step 6 Copy the startup configuration to running configuration.Switch# copy startup-config running-config Destination filename [running-config]?

版权声明：本文内容由网络用户投稿，版权归原作者所有，本站不拥有其著作权，亦不承担相应法律责任。如果您发现本站中有涉嫌抄袭或描述失实的内容，请联系我们jiasou666@gmail.com 处理，核实后本网站将在24小时内删除侵权内容。