Spring中的aware接口详情
254
2022-10-27
Juniper ScreenOS 路由策略配置
一、拓扑图场景介绍:
两条ISP线路分别接入SSG5的E0/0和E0/1口
VLAN1:172.16.1.0/24的流量要求走E0/0口
VLAN2:172.16.2.0/24的流量要求走E0/1口
二、定义ACL(在路由配置模式下)
set vrouter "trust-vr" set access-list extended 10 src-ip 172.16.1.0/24 dst-ip 0.0.0.0/0 src-port 1-65535 dst-port 1-65535 protocol any entry 10 set access-list extended 10 src-ip 172.16.1.0/24 dst-ip 0.0.0.0/0 protocol icmp entry 20 set access-list extended 20 src-ip 172.16.2.0/24 dst-ip 0.0.0.0/0 src-port 1-65535 dst-port 1-65535 protocol any entry 10 set access-list extended 20 src-ip 172.16.2.0/24 dst-ip 0.0.0.0/0 protocol icmp entry 20 exit
三、定义match group(在路由配置模式下)
set vrouter "trust-vr" set match-group name group_10 set match-group group_10 ext-acl 10 match-entry 10 set match-group name group_20 set match-group group_20 ext-acl 20 match-entry 10 exit
四、定义action group(在路由配置模式下)
set vrouter "trust-vr" set action-group name action_10 set action-group action_10 next-interface ethernet0/0 action-entry 10 set action-group name action_20 set action-group action_20 next-interface ethernet0/1 action-entry 10 exit
五、定义policy(在路由配置模式下)
set vrouter "trust-vr" set pbr policy name pbr_trust set pbr policy pbr_trust match-group group_10 action-group action_10 10 set pbr policy pbr_trust match-group group_20 action-group action_20 20 exit
六、配置policy binding(在配置模式下)
set pbr pbr_trust set zone Trust pbr pbr_trust set interface bgroup0 pbr pbr_trust set interface bgroup1 pbr pbr_trust set interface bgroup2 pbr pbr_trust set interface bgroup3 pbr pbr_trust
版权声明:本文内容由网络用户投稿,版权归原作者所有,本站不拥有其著作权,亦不承担相应法律责任。如果您发现本站中有涉嫌抄袭或描述失实的内容,请联系我们jiasou666@gmail.com 处理,核实后本网站将在24小时内删除侵权内容。
发表评论
暂时没有评论,来抢沙发吧~