GNS3 V1.5.2 与IOU L2 L3的集成

GNS3 V1.5.2 与IOU L2 L3的集成

After some years, it's time again to prepare for my next CCNP re-certification. I was pleasantly surprised that running full-featured Cisco L2 p_w_picpaths is now made entirely possible with the new "IOS on Unix (IOU)" function on GNS3. I documented my new setup here according to the GNS3 v1.5.2 running on a Windows x64 host.

You'll need to get hold of the following files beforehand:

Cisco IOU L2 and L3 p_w_picpaths (by Googling)Cisco IOU license file iourc (see this forum discussion)

Once you have obtained the above files, you can now proceed with the following steps:

Note: if you are unable to start the new IOU devices, you may need to modify the hostname on your GNS3 VM according to your iourc file content. For example:

gns3@gns3-vm~#sudo hostnamectl set-hostname gns3-iouvm

gns3@gns3-vm~#bash

版权声明：本文内容由网络用户投稿，版权归原作者所有，本站不拥有其著作权，亦不承担相应法律责任。如果您发现本站中有涉嫌抄袭或描述失实的内容，请联系我们jiasou666@gmail.com 处理，核实后本网站将在24小时内删除侵权内容。